Your Source for Woodworking & WoodcarvingWoodworking & Woodcarving Crafts

How does the panel hv distribute the load of processors and boards MT?

Please let me understand what is flow load electrecal through the departure process of the high load, until it reaches the switchboard. Thank you

The size of the driver depends on the amount of current passing through the same, for the same load, the current in HV should be reduced compared to BT. Taking this principle, the distribution voldage High / transmission has been adopted. In general, the production of electricity at low voltage is Done (Higher voltage required high isolation and the size and the cost of the generator should increase). Moreover, thanks to a transformer voltage is high and it is transmitted to the distribution center near. (They are big transmission lines in length and adopting high voltage, cinductor size is reduced, the cost is reduced) Nera load center again reinforced by the voltage transformers at the medium voltage. Power other wheels closer to load and then finally resigned from work stress level and distributed to the voltage tis. In high-voltage lines carry more large amount of energy, to receive the power is distributed to many departures medium voltage and medium voltage power mode is similar distributed to uses low voltage. For this distribution, switching / switching are installed. He will have the power throgh a newcomer, breakler and bars are more of the busbar, outgoing feeders are connected. Each HV post must be connected to the HV / MV transformer MT Whoose liquidation Food This switchgears.Further MV MV switchgear, outgoing must be connected to MV / LV transformer LV winding shall feed Whoose switching BT and additional charges low voltage ..

DIY 4 Panel wooden Door, part 4. raised panel cutting with a straight router